Golden Arrow Frame-Buggy Radio Controlled Off-Road Racing Car
(600-4080)                 Install/Replace Parts      Faxback Doc. # 41727

Installing The Replacement Parts

Installing A Tire and Wheel Set

  No. RC-0024 Front Wheel + Front Tire) x2, M4 Nylon Nut x2

  Tighten the nylon nut using the box wrench.

  However, DO NOT OVERTIGHTEN.

  No. RC-0025 (Rear Wheel + Rear Tire) x2, M4 Nylon Nut x 2

Installing A Bumper Set

  No. Z-2014 Front Bumper x 1, Side Guard (Right) x 1, Side Guard (Left)
  x 1, Tapping Screw (3 x 10) x 6,

Removing The Pivot Shaft

Remove the bushing.  Then, you can remove the pivot shaft. For reinstall-
ation, we recommend you obtain a new pivot shaft (RK-0008).

Installing a Pivot Shaft Set

The rubber washers on the front and rear suspension act as shock absorbers.
You can adjust the shock absorbing action by tightening or loosening the
nylon nuts.  In most cases, use a tighter adjustment when racing on rough
surfaces and a looser adjustment when racing on smooth surfaces.

NOTE:  Adjustment of the nylon nuts is especially important for the front
       suspension. If they are too loose, the suspension arm might come off
       during racing.  If they are too tight, they might make the racer
       difficult to drive in a straight line.


(br/EB 9/16/97)