This tutorial covers programming Trunked Motorola frequencies into your PRO-92 Scanner. For this example, we are programming the frequency 866.1625 MHz into Bank 0 Channel 00.
For additional information on this product, see the links below:
|Step 1: Select the Channel|
|Press MANUAL, enter the channel number where you want to store a frequency, then press MANUAL again. M and the channel number appear at the upper left corner on the display (for example, M000).|
|Step 2: Enter the Program Mode|
|Press PGM. M changes to P on the display.|
|Step 3: Enter the Frequency|
|Use the number keys to enter the frequency (including the decimal point) you want to store.|
|Click Here for the Police Call Frequency Lists on CD|
|Step 4: Clear a Mistake|
|If you make a mistake, hold down CL for about 0.5 seconds to delete a single digit and about 1.5 seconds to delete all digits.|
|Step 5: Stor the Frequency|
|Press ENTER to store the frequency into the channel. The
blinking cursor disappears.
Note: If you made a mistake entering the frequency, Invalid Freq. briefly appears and the scanner beeps when you press ENTER. Start again from Step 3.
|Step 6: Turn Off Delay|
|Trunked frequencies must have delay turned off. When delay is turned off, the circled area on the display should be a dot. If the letter D appears, press FUNC then press DELAY/1 so that the D becomes a dot as shown above.|
|Step 7: Select the Trunking Mode|
|Press MODE until MO for Motorola systems appears. Then the next channel in sequence is ready for programming.|
|Step 8: Program the Next Channels|
|Press PGM or the UP ARROW key so that the number in the circled area changes to the next channel number, then repeat from Step 3 to program additional channels.|
|Step 9: Set the Bank Mode|
|Press FUNC 2 to put the bank in OPEN (+) or Closed (-) mode.|
|Step 10: Start Scanning|
|To start scanning, press SCAN.|
Copyright© RadioShack Corporation 2002. All rights reserved.