HTX-400 Mini Handheld 70-Centimeter FM Amateur Transceiver
(190-1104)                 Using Menus                Faxback Doc. # 61413

Using the HTX-400's Menus

The HTX-400 provides two menus to access its features, the Main Menu and 
the Tone Set Menu.  To see details about each operation, refer to the 
Faxback Doc. number in the following chart.

To access the Main Menu, hold down FUNC while turning on the HTX-400. (The 
CS option appears).  Hold down FUNC then repeatedly press \/ or /\ to step 
through the other options.  Release FUNC and press /\ or \/ to change an 
option's setting.

                   Setting ()=
Main Menu           Default                                       Faxback
Options             Setting           Description                  Doc. #

CS                .0050(MHz),         Sets the increment for        61417
Frequency         .0100,              scanning the band.
Step              .0125, .0150,
                  .0200, (.0250),
                  .0500, 1.000

bCLO              (Off) On            Prevents transmitting while   61417
Busy Channel                          receiving a signal.
Lockout

t.dY              Off (On)            Prevents Squelch tail.        61417
Transmit                 
Delay Time      

Sd                1 to 30 Seconds     Sets the scanning restart     61416
Scan Delay        (5)                 time.
Time

tot               (Off)               Limits transmit time.         61417
Time out          On 10-990 seconds
Timer

PS                (Off) On            Cycles power (PS flashes)     61417
Power Save                            to the receiver section to 
                                      conserve batteries. The
                                      Circuit remains off then
                                      turns on briefly to check
                                      for an incoming signal.

rPt               0.0 - 8.0 MHz in    Sets the offset in 100 kHz    61415
Repeater          100 kHz steps.      steps between the repeater's
Offset            (5.0)               transmit and receive
                                      frequencies.

The Tone Set Menu lets you set features that relate to sound and the CTCSS
tones.  To access these settings, turn on the HTX-400 then hold down FUNC
and press T.SET.  (The tone option appears.) Press FUNC + /\ or \/ to
select the option, then /\ or \/ to change the setting.

                   Setting ()=
Tone Set            Default                                       Faxback
Option              Setting           Description                  Doc. #

tone              (Off) On            Lets the HTX-400 transmit     61416
Subaudible                            and receive the Subaudible
Tone                                  Tone (CTCSS) frequencies so
                                      you can listen only to other
                                      units with the same tone.

RC Receive        See the table       Lets you select one of 47     61416
Tone              on Faxback Doc.     different receiving sub
                  # 61416. (110.9)    audible tones or turn the
                                      feature off.

TC Transmit       See the table       Lets you select one of 47     61416
Tone              on Faxback Doc.     different subaudible tones
                  # 61416. (110.9)    or turn the feature off.

MEL               (1), 2, 3, 4, 5     Lets you select a tone to     61416
Tone Paging                           receive or transmit.

(BR EB 8/30/00)

Privacy Policy