DSP Noise Reduction System  (210-0543)    Mounting      Faxback Doc. # 6410

MOUNTING THE SYSTEM

Follow these steps to mount the system in your vehicle.

1.  Choose a location for the mounting bracket.  Be sure you mount the
    system close enough to allow convenient operation while you drive
    your vehicle.

2.  Using the mounting bracket as a template, draw two oval marks on the
    mounting surface.

3.  Drill holes 7/32-inch in diameter within each mark, being careful not
    to drill into object behind the mounting surface.

4.  Place the mounting bracket over the holes with the open slots facing
    away from you.  Secure the bracket using the supplied bolts, spring
    washers, plan washers, and nuts.

Notes:

  If you cannot reach behind the mounting surface to attach the nuts on
  the bolts, use the supplied self-tapping screws, plain washers, and
  spring washers to secure the bracket.

  If you use the supplied self-tapping screws, drill holes 5/32-inch in
  diameter in Step 3.

5.  Position the system inside the bracket.  Then slide the mounting tabs
    on the bottom of the system into the slots on the bracket until the
    system locks into place.

To release the system from the bracket, press the lock tabs and slide the
system away from the bracket slots.

(LB/smc-04/27/94)

Privacy Policy