Deluxe Ni-CAD Battery  (230-0134)      Operation       Faxback Doc. # 15202
Charger

1.  Open the transparent cover and install the batteries to be charged.
    The chambers adjust automatically to the different sizes of batteries.
    9-volt batteries snap into the special connectors between the large
    chambers.

    Be sure to observe proper polarity (+ and -).  Failure to do so can
    damage the charger and/or batteries.

    Only charge nickel-cadmium batteries (D, C, AA, 9V) in the battery
    charger.

2.  Use the four large chambers to charge 2, 4, 6 or 8 batteries of sizes
    AA, C and D.  Place two batteries into each of the large chambers.
    Make sure that the two batteries are the same size and are facing the
    correct direction.  Do not attempt to charge only one battery or two
    different sizes of batteries in the large chambers.

    Use the two small chambers to charge one battery each.  You can charge
    either two different sizes or the same size of AA, C or D batteries.

    Use the three 9-volt terminals located between the large chambers to
    charge 1, 2 or 3 9V batteries at once.  Remember not to use the large
    chamber with C or D batteries at the same time that you are charging
    9-volt batteries.

3.  Close the cover.  Keep the cover closed when charger is operating.

4.  Plug the battery charger into a standard AC outlet (120V, 60Hz).  Each
    charging indicator LED lights when its respective chamber is in use.
    When all the chambers are in use, six charging indicators will light.
    They remain lighted even after the batteries are charged.  Make sure
    the indicators are lighted, or the battery is not charging.

5.  After charging your batteries, unplug the charger and remove the
    batteries.  Store the charger carefully until its next use.  A full
    charge will take 14-16 hours; however, the batteries will not be
    damaged by overcharging.  The recharged batteries can be used in the
    same manner as dry cells.


(br/all-05/08/95)

Privacy Policy