Compaq Presario 1220 Notebook
(250-0325)       Installing the CD Bundle Pack        Faxback Doc. # 47402

To install the programs included in the CD Bundle Pack, follow the steps
below:

TO INSTALL MOTO RACER

1.  It is recommended to exit out of all other programs for this
    installation program.

2.  Insert the disk into the CD-ROM drive.  The CD will load automatically.

3.  The Moto Racer main screen comes up.  Click on the Install button.

4.  This will load and create the Setup Wizard.  Click on Next.

5.  At the next screen (where the Wizard tells you where it is going to
    install Moto Racer) press Next to accept the default or click on Browse
    to tell the Wizard where you want Moto Racer to install.

6.  At the next screen, choose the installation type and click Next.

7.  The program will now be installed.

8.  At the next screen, click OK.

9.  You will be asked if you need to install DirectX.  Click on No.

ENTERING YOUR NAME FOR MOTO RACER

After pressing Start to play Moto Racer, you will be prompted to enter your
name.  At this time, a Moto Race screen with letter should appear so that
you can enter your name.  If a Moto Racer screen with letters does not
appear, follow the instructions below to enter your name:

1.  Press the ALT+TAB keys.  The Moto Racer screen minimizes.

2.  Press the ALT+TAB keys again.  A Moto Racer screen with letters
    appears.

3.  Enter your name and click on the arrow similar to the one on the enter
    key.


TO INSTALL MICROSOFT BOOKSHELF 98

1.  Insert the CD into the CD-ROM drive.  The CD will load automatically.

2.  At the Setup screen, click Continue to have the system install]
    Bookshelf into the default directory, or press Browse to specify a
    location for installation.

3.  The system will now install Bookshelf.

4.  After installation is complete, you will be offered a chance to
    register Bookshelf or not.  Click on your choice and follow the
    prompts.

TO INSTALL MICROSOFT ENCARTA 98 ENCYCLOPEDIA

1.  Insert the CD into the CD-ROM drive.  The CD will load automatically.

2.  At the Setup screen, click on Next.

3.  You will then be brought to the End-User License Agreement screen.
    Click on Accept.

4.  At the next screen, you will have a choice to have Setup install
    Encarta in its default directory by clicking Next or choose Browse to
    specify a location.

5.  Click Finish to begin the installation.

6.  At the Setup Complete screen, Encarta is installed.  If you click on
    Run, you will be taken into Encarta98.

(smm -- 04/02/98)