IBM Aptiva C66/S7H
(250-0458/0460)            Event Scheduling           Faxback Doc. # 41184

This section lists the Home Director Voice Command Phrases used to schedule
a module or routine that has been previously selected.  To see the commands
used to perform a particular function, refer to the following function that
you would like to perform.

Schedule an Event Time

To Schedule an event time, say: TURN ON AT or TURN OFF AT followed by a
time (ie., 1:30 pm) or the word DUSK or the word DAWN.

The command word TURN can be left off, so that the command is simply ON AT
or OFF AT as shown in the samples below.

  Sample Phrases: On At Dawn
                  Off At Dusk
                  Turn On At 10:30 AM
                  Turn Off At Noon

Select Day for an Event

To select a specific day for an event, say one of the following:

   Monday 
   Tuesday
   Wednesday
   Thursday
   Friday
   Saturday
   Sunday
   Today
   Tomorrow
   Weekdays
   Weekends
   Every Day

Select Dates for an Event

To select specific dates for an event, either say: FROM and a start date
(ie., month day) TO and an end date (ie., month day). The command word FROM
can be left off, so that the command is simply start date TO end date as
shown in the samples below or START or STOP with or without the word ON and
a date (ie., month, day).

  Sample Phrases: From April 2 To July 12
                  September 15 To September 30
                  Start February 22
                  Start On June 20
                  Stop On May 25

Set The Brightness Level for an Event

To select a specific brightness level for a Lamp module event, either say:
DIM TO with a percentage (0-100) with or without the word PERCENT or SET
BRIGHTNESS AT or SET BRIGHTNESS TO with a percentage (0-100) with or with-
out the word PERCENT.

  Sample Phrases: Dim To 65
                  Dim To 30 Percent
                  Set Brightness At 80
                  Set Brightness To 75
			Set Brightness To 37 Percent


(EB 8/20/97)

Privacy Policy