IBM Aptiva Axx/Mxx
Setup Faxback Doc. # 34618
Press F1 when it is displayed on the computer screen during boot up to go
into the setup program.
IBM Aptiva Axx/Mxx Computer Setup Information
---------------------------------------------------------------------------
Main Menu Screen
IBM SurePath Setup Utility
Main Menu
Select a Menu
ø System Information
ø Video and Monitor
ø Disk Drives
ø Input/Output Ports
ø Rapid Resume
ø Plug and Play
ø Startup Options
ø Model Information
ø Date and Time
ø Advanced Options
<F1> Help <F2> General Help <F5> Load Factory Settings
<Esc> Exit Setup (Up and down arrows) Move <Enter> View Menu
---------------------------------------------------------------------------
System Information Screen
IBM SurePath Setup Utility
System Information
Processor Pentium
Processor Speed 166 MHz
Math Coprocessor Internal
System Memory 16834 KB
Memory Type Non-parity
Cache Size 0 KB
Video Memory 1024 KB
Diskette Drive A: 1.44 MB 3.5"
Diskette Drive B: Not installed
Hard Disk Drive 1 1707 MB
Hard Disk Drive 2 Not installed
CD-ROM Drive 3 Installed
Hard Disk Drive 4 Not installed
Serial Port A 3E8h-IRQ 4
Serial Port B 2F8h-IRQ 3
Parallel Port 3BCh
Mouse Installed
<F2> General Help
<Esc> Previous Menu
---------------------------------------------------------------------------
Video and Monitor Screen
IBM SurePath Setup Utility
Video and Monitor
Video Controller Trident TGUI96xx
Video Memory 1024 KB
Monitor Setup [Plug and Play / DDC]
(Other choices:
Set Refresh Rate
Set Frequency)
Monitor Horizontal Frequency[Not Used ]
(Other Choices with Set Frequency chosen:
Undefined
31.5 KHz (VGA)
31.5 - 36.9 KHz
37.0 - 37.9 KHz
38.0 - 48.9 KHz
49.0 - 59.9 KHz
60.0 - 67.9 KHz
68.0 - 78.9 KHz
79.0 - 89.9 KHz
90.0 - 95.0 KHz )
(Refresh Rates will change automatically
based upon the frequency chosen.)
Refresh Rates (with Plug and Play / DDC chosen in Setup)
640 x 480 Resolution [60 Hz]
800 x 600 Resolution [Not Supported]
1024 x 768 Resolution [Not Supported]
1280 x 1024 Resolution [Not Supported]
1600 x 1200 Resolution [Not Supported]
(Other choices with Set Refresh Rates chosen)
640 x 480 Resolution [60,72,75,85 Hz]
800 x 600 Resolution [Not Supported,
60,75,85 Hz]
1024 x 768 Resolution [Not Supported,
87 Hz interlaced,60 Hz
70 Hz, 75Hz]
1280 x 1024 Resolution [Not Supported,
87 Hz intrlaced,60 Hz]
1600 x 1200 Resolution [Not Supported,
96 Hz Interlaced]
<F1> Help <F2> General Help <Right Arrow> Next Value
<Esc> Previous Menu <Up & Down arrows> Move <Left Arrow> Previous Value
---------------------------------------------------------------------------
Disk Drives Screen
IBM SurePath Setup Utility
Disk Drives
Diskette Drive A: [1.44 MB 3.5"]
Diskette Drive B: [Not Installed}
(Other disk drive choices: Not Installed, 360 KB 5.25",
1.2 MB 5.25", 1.44 MB 3.5", 2.88 MB 3.5")
. Hard Disk Drive 1
. Hard Disk Drive 2
. CD-ROM Drive 3
. Hard Disk Drive 4
<F1> Help <F2> General Help <Up & Down Arrow> Move
<Esc> Previous Menu <Enter> View Menu
---------------------------------------------------------------------------
(Since "." in front of Hard Disk area has a submenu option.)
Example:
Hard Disk Drive 1
Size 1707 MB
Local Bus IDE Mode [High Performance]
(Other choice: Compatible {will gray out Read
Prefetch if chosen})
Read Prefetch [Disabled] (Other choice: Enabled)
Disk BIOS Translation [Enabled] (Other choice: Disabled)
Parameter Table Type [Enhanced] (Other Choice, if Disk BIOS
Translation is enabled,
Standard)
CD-ROM Drive 3
Size Installed
Local Bus IDE Mode [High Performance]
(Other choice: Compatible {will gray out Read
Prefetch if chosen})
Read Prefetch [Disabled] (Other choice: Enabled)
<F1> Help <F2> General Help <Right Arrow> Next Value
<Esc> Previous Menu <Up & Down arrows> Move <Left Arrow> Previous Value
---------------------------------------------------------------------------
INPUT/OUTPUT PORTS
Serial Port A [3E8h - IRQ 4 ] 2E8h, Disabled
Serial Port B [2F8h - IRQ 3 ] 2E8h - IRQ 3, Disabled
Parallel Port [3BCh ] 378h, 278h, Disabled
Parallel Port Mode [compatible ] PS/2 Bidirectional, ECP
* note - compatible is normal - other modes are bidirectional.
Mouse [ Installed ] Not installed
Keyboard NumLock State [ ON] Off
Keyboard Speed [ Fast ]
Mwave Adapter [Installed] Not Installed
<F1> Help <F2> General Help <Right Arrow> Next Value
<Esc> Previous Menu <Up & Down arrows> Move <Left Arrow> Previous Value
___________________________________________________________________________
RAPID RESUME
APM BIOS Mode [ 32 Bit Protected ] 16 and 32 Bit, Disabled, Real Mode Only,
16 Bit Protected
Rapid Resume [ Disabled] Enabled
***the following two options are grayed if Rapid Resume is Disabled ***
Automatic Power Off [Disabled ] 10, 15, 20, 25, 30, 40, 50, 60, 70, 80, 90,
Disabled
Initialize Adapter Cards [Disabled] Reload Device Drivers
Stand by Timer [15 ] 20, 25, 30, 40, 50, 60, 70, 80, 90, Disabled
***the following option is grayed if Rapid Resume is disabled ***
Stand by Snapshot [Disabled] Enabled
***the following three options are grayed if Standy by Timer is Disabled***
Halt CPU when Idle [Enabled] Disable
Monitor Mode [VESA Standyby] Lowest Power
Blink LED in Standby [Disabled ] Enabled
Wake Up on Ring [ Disabled ] Enabled
***the following option is grayed if WAke Up on Ring is Disabled***
Indicator [ Disabled ] Enabled
Wake Up on Alarm [ Disabled ] Single Event, Daily Event
***the following two options are grayed if Wake up on Alarm is Disabled ***
Alarm Date [05/23/96]
Alarm Time [10:53]
<F1> Help <F2> General Help <Right Arrow> Next Value
<Esc> Previous Menu <Up & Down arrows> Move <Left Arrow> Previous Value
___________________________________________________________________________
PLUG AND PLAY
Plug and Play Cards Detected
** will only have options if plug and play card detected
___________________________________________________________________________
STARTUP OPTIONS
First Startup Device [Diskette Drive A:] Hard Disk 1, Disabled
***other startup devices are grayed if First Startup Device is Disabled ***
Second Startup Device [Hard Disk 1] Disabled
*** the Third and Fourth devices are only available if you have a second or
third hard drive ***
Third Startup Device [Disabled]
Fourth Startup Device [Disabled]
System Memory Test [ Enabled] Disabled
Virus Detection [Enabled ] Disabled
___________________________________________________________________________
MODEL INFORMATION
Model Number 2168A40
Serial Number 2331PLB
BIOS Version BG2US0J
BIOS Date 03/06/96
*** note- this information is particular to your machine***
___________________________________________________________________________
DATE AND TIME
Date [05/29/1996]
Time [12:28:08]
___________________________________________________________________________
SECURITY OPTIONS
Power-on Password
Diskette Drive Access [Enabled] Disabled
Operate without Keyboard [Disabled] Enabled
Operate without Diskette Drive(s) [Disabled] Enabled
___________________________________________________________________________
POWER-ON PASSWORD
Power-on Password Status Disabled
Enter your new Power-on Password twice. The Power-on Password may be up to
seven characters long.
Enter Power-on Password [ ]
Enter Power-on Password Again [ ]
Set or Change Power-on Password
Delete Power-on Password
Password Prompt [On ] Off
___________________________________________________________________________
Change Power-on Password
The new Power-on Password will replace the existing Power-on Password.
Press <Enter> to continue
___________________________________________________________________________
Delete Power-on Password
The existing Power-on Password will be deleted.
Press <Enter> to continue
___________________________________________________________________________
CACHE OPTIONS
F000-FFF (System BIOS) Enabled
E800-EFFF (Rapid Resume BIOS) Enabled
E000-E7FF (System POST) Enabled
D800-DFFF (Adapter ROM) [Disabled] Enabled
D000-D7FF (Adapter ROM) [Disabled] Enabled
C800-CFFF (Adapter ROM) [Disabled] Enabled
C000-C7FF (Adapter Video BIOS) [Enabled] Disabled
Upper Memory Boundary F400
___________________________________________________________________________
MEMORY OPTIONS
Memory Bank 1 [Standard] EDO
Memory Bank 2 [Standard] EDO
___________________________________________________________________________
PCI CARD OPTIONS
PCI-1 Card Bus Mastering [Enabled] Disabled
PCI-2 Card Bus Mastering [Enabled] Disabled
___________________________________________________________________________
EXIT SETUP UTILITY
Do you want to exit the Setup Utility?
Yes, Exit the Setup Utility.
No, return to the Setup Utility.
___________________________________________________________________________
(DM/JN/BKL-09/17/96)
Privacy Policy