IBM Aptiva Personal Computer
(250-0451A)        Disabling The Joystick Port        Faxback Doc. # 33151

To disable the joystick port on your Mwave adapter card, you must change
the joystick jumper.  Before you change the joystick jumper, you may need
to remove the Mwave adapter card.  See "To remove the Mwave adapter card:"
on page 19 for instructions.

To change the joystick jumper:

1.  Locate the jumper labeled P10 on your Mwave adapter card.

2.  Move the jumper from the enabled position to the disabled position as
    shown in the picture.

3.  Align and insert the Mwave adapter card into the adapter card connector
    from which you removed it.  Insert the screw.

4.  Reattach the cables to the Mwave adapter card.

If you need more information about Mwave card that is already installed in
your computer, please refer to the documentation that came with it.

NOTE:  The documentation that came with your Mwave card may either be on
       line or in a printed book.


(br/all-06/03/96)

Privacy Policy