1800 HD  (250-3502)           Power Utility             Faxback Doc. # 1870

Using the Power Utility:

FDC STANDBY MODE               ENABLE
SERIAL PORTS                   DISABLED
HARD DISK TIMEOUT              Never Timeout
DISPLAY TIMEOUT                Never Timeout
STANDBY MODE TIMEOUT           Never Timeout

The power180 program lets you temporarily change the timeout parameters
and other power management parameters without rebooting the computer.
However, changes you make using this program are not stored in memory,
and when you reboot the computer, it returns to the parameters you stored
using the setup180 program.

NOTE: You cannot enable power management parameters when using AC power.
If you make changes, the changes are ignored until you switch to the
internal battery power.

The power management parameters let you enable or disable the floppy disk
controller, enable or disable the serial ports, or set the hard disk and
display to automatically turn off after a selected period of inactivity.
Of course, you can turn the hard drive and display on again whenever
you need them. You can also set the Standby mode to automatically activate
when there is not a disk in the floppy drive, hard drive, port or keyboard
activity.


(smm 08/06/93)

Privacy Policy