SCR-60 (140-0707) Operation Faxback Doc. # 9962
Warning: To protect your hearing, set VOLUME near its lowest setting
before you turn on the radio.
Follow these steps to use the radio.
1. Set the function switch to RADIO.
2. Set BAND to select the band.
3. Turn TUNING to tune to the desired station.
Notes: The SCR-60 has two antennas. The AM Antenna is built-in.
Rotate the recorder to improve AM reception. For FM
reception, fully extend the telescoping antenna and adjust it
to the position that provides the best reception.
To improve reception for weak FM radio stations, set AM/FM/FM
STEREO to FM. The sound changes from stereo to monaural
(mono), but the sound quality improves.
4. Set VOLUME to a comfortable listening level.
5. Set E-BASS to IN to emphasize bass sound. Set it to OUT for normal
bass sound.
6. For FM stereo stations, adjust BALANCE to achieve the best stereo
effect.
7. To turn off the radio, set FUNCTION to RADIO OFF/TAPE.
CASSETTE PLAYER OPERATION
Follow these instructions to operate the cassette tape recorder.
LOADING A CASSETTE TAPE
Follow these steps to load a cassette tape:
1. Press STOP/EJECT to open the cassette compartment's door.
2. Use your finger or a pencil to turn the cassette's hub and take up
any tape slack. Do not touch the tape with your fingers.
3. Load the cassette with its open edge facing up and the desired tape
side facing you.
Note: To hear the entire tape be sure the cassette's full reel is on
the right. If necessary, press REWIND, to rewind the tape.
Press STOP/EJECT when the deck completely rewinds the tape.
4. Close the compartment's door.
PLAYING A CASSETTE TAPE
Warning: To protect your hearing, set VOLUME to its lowest level before
you begin playing the tape.
1. Set FUNCTION to RADIO OFF/TAPE
2. Select the auto-reverse mode as follows:
For one-time play, press MODE so the button locks down. When the tape
reaches the end of the first side, the tape direction reverses and
play continues on the second side. At the end of the second side,
play automatically stops.
For continuous play, press MODE so the button releases. Each time
the tape reaches the end of a side, the tape direction reverses and
play continues on the other side. Play continues until you press
STOP.
3. Press PLAY.
Note: If you play a cassette tape several times, the tape can become
lightly wound on either hub. This can cause distortion. To
restore the correct tension, fast-forward through the entire
cassette and then completely rewind it.
4. Set VOLUME to a comfortable listening level.
5. Set E-BASS to IN to enhance the bass sound effects. Set it to OUT
for normal bass sound.
6. Turn BALANCE to achieve the best stereo effect.
Notes: Press Fast-F or REWIND to forward or rewind the tape to the
desired selection.
Press DIRECTION to reverse the tape's direction and play the
other side. The tape direction indicator shows the current
tape direction.
Press PAUSE to temporarily stop play.
Press PAUSE again to resume play.
7. Press STOP/EJECT to stop the tape. Press STOP/EJECT again to open
the cassette compartment, then remove the cassette tape.
RECORDING A CASSETTE TAPE
You can record from the radio or use the built-in microphone to make a
live recording.
Notes: Tape quality greatly affects the quality of the recording. We
recommend Supertape Extended-Range or Low-Noise Type 1 tape. Do
not use C-120 cassettes. Their tape is extremely thin and tangles
easily.
The recorder's automatic level control (ALC) automatically adjusts
the recording level. Adjusting VOLUME does not affect recording.
Before you record, be sure the tape's erase-protection tabs are in
place. After you record, you can remove the tape's erase-
protection tabs to prevent accidental erasure of the recording.
Before you load the cassette tape, turn the cassette's hub with
your finger or a pencil to position the tape past the leader.
To temporarily stop recording, press PAUSE. Press PAUSE again to
resume recording.
RECORDING FROM THE BUILT-IN RADIO
Follow these steps to record radio broadcasts.
1. Set FUNCTION to RADIO.
2. Set BAND to the desired band. Then, turn TUNING to the desired
station.
3. Load a cassette tape in the cassette compartment. See "Loading a
Cassette Tape."
4. Press PLAY and check to be sure the forward (<-) direction indicator
is on. If not, press DIRECTION to change the tape's direction;
then, press STOP. You might need to rewind the tape.
Caution: The SCR-60 records only when the tape is turning in the
forward (<-) direction. You cannot press down RECORD if the
tape is turning in the reverse (->) direction. Do not force
down RECORD.
Note: You might hear a hum or whistling sound in the background on
some AM radio recordings. To reduce or eliminate this sound,
set BEAT CUT on the back of the SCR-60 to the position that
gives you the best quality recording.
5. Press STOP/EJECT to stop recording.
To resume recording on the other side of the tape, turn over the tape, and
follow Steps 4 through 5.
If you do not manually stop recording, the player automatically reverses
the tape direction when the tape reaches its end, begins playing the
other side, RECORD releases.
RECORDING THROUGH THE BUILT-IN MICROPHONE
Follow these steps to make a live recording.
1. Set FUNCTION to RADIO OFF/TAPE.
2. Load a blank cassette tape in the cassette compartment. See "Loading
a Cassette Tape."
3. Press PLAY and check to see whether the forward (<-) direction
indicator is on. If not, press DIRECTION to change the tape's
direction; then, press STOP. You might need to rewind the tape.
Caution: The SCR-60 records only when the tape is turning in the
forward (<-) direction. You cannot press down RECORD if
the tape is turning in the reverse (->) direction. Do not
force down RECORD.
4. Before you record, be sure MODE is not pressed down. If necessary,
press MODE to release the button.
5. Press RECORD to begin recording. RECORD, PLAY and MODE lock down.
6. Press STOP/EJECT to stop recording.
To resume recording on the other side of the tape, turn over the tape, and
follow Steps 3 through 6.
If you do not manually stop recording using the microphone, when the tape
reaches its end, RECORD and MODE release and the player automatically
reverses the tape direction and begins playing the other side.
USING HEADPHONES
For private listening, connect a pair of optional stereo headphones with a
1/8-inch plug to the SCR-60. Your local Radio Shack store sells a wide
selection of stereo headphones.
CONNECTING HEADPHONES
Insert the headphone's 1/8-inch plug into the recorder's PHONES jack.
This automatically disconnects the recorder's internal speaker.
Listening Safely
To protect your hearing, follow these guidelines when you use headphones.
Do not listen at extremely high volume levels. Extended high-volume
listening can lead to permanent hearing loss.
Set the volume to its lowest level before you begin listening. After
you put on the headphones, adjust the volume to a comfortable
listening level.
Do not increase the volume once you have established a comfortable
listening level. Over time, your ears adapt to the volume level, so
a volume level that does not cause discomfort might still damage
your hearing.
Traffic Safety
Do not wear headphones while operating a motor vehicle or riding a
bicycle. This can cause a traffic hazard and is illegal in some areas.
Even though some headphones are designed to let you hear outside sounds
when listening at normal volume levels, they still present a traffic
hazard.
(br/all-03/06/95)
Privacy Policy