Wireless Microphone System
(320-1221C)                Operation                  Faxback Doc. # 63709

Using the Microphone

1.  Clip the microphone three to six inches from your mouth.

2.  Clip the transmitter to your belt or pocket.

3.  Set POWER to ON.  The POWER indicator lights.

4.  Fully extend the receiver's telescoping antenna.

5.  Set the transmitter's OFF/STANDBY/TALK switch to TALK.  The READY
    indicator lights.

6.  Speak normally and adjust VOLUME on the receiver and/or your amplifier
    to the desired level.

When you finish talking, be sure to move the switch to OFF to conserve 
battery power.

Note: Turn off any receiver channels before turning off your transmitter
      to prevent "pops".

Using Mute

If you want to momentarily turn off the microphone, press and hold MUTE.  
When you are ready to talk again, release MUTE.

Using Standby

Standby lets you control the microphone, but avoid the popping noise that 
might occur if you move OFF/STANDBY/TALK to OFF, then back to TALK.

If you want to turn off the microphone for a long period of time without 
turning off the transmitter, set OFF/STANDBY/TALK to STANDBY.  The READY 
indicator stays lit.

When you are ready to talk again, set OFF/STANDBY/TALK to TALK.

Channels of Operation

The wireless microphone system is available in two different frequencies, 
49.830 MHz or 49.890 MHz.  This lets you use up to two microphones at the 
same time on different frequencies without interference.

You can use only one wireless microphone with the same frequency as the 
receiver at a time.  To use two microphones, you must use a microphone and 
a receiver with the other frequency.

(EB 1/4/1)

Privacy Policy