8-Channel 900 MHz Wireless Microphone
(320-1251)                 Operation                  Faxback Doc. # 63540

Using the Microphone

1.  Follow the directions in the receiver's owner's manual to set up and
    power on the receiver.

2.  Turn on the amplifier, tape recorder, mixing board and other necessary
    components of your audio system.  Set the components' volume control
    (or input level controls) to moderate settings.

3.  Set the receiver and microphone's channels to the same settings (see
    "Setting the Channel" in Faxback Doc. # 63539).

4.  Slide STANDBY ON/OFF on the microphone to ON.  (When power is on and
    the battery is good, LOW BATT lights.)

5.  Set TALK/MUTE to TALK.  Begin to talk into the microphone and adjust
    the receiver's volume control as desired.

    Note: Experiment with the receiver's volume and the settings of other
          components in your audio system to obtain the best results.

6.  When you finish, slide STANDBY ON/OFF to OFF.

Using Mute

Slide TALK/MUTE to MUTE to temporarily turn off the microphone's sound 
without turning off its power.

If you turn off the microphone (slide STANDBY ON/OFF from ON to OFF) while 
the amplifier is on, the speakers emit a loud pop.  When you use MUTE, 
there is no pop.

(EB 12/7/00)

Privacy Policy