Multi-Channel Professional Wireless Microphone
(320-1230A)                Operation                  Faxback Doc. # 61080

Be sure to read this manual, and the manuals for your other audio 
equipment, before you use the wireless microphone.

1.  Fully extend the receiver's antenna.

2.  Turn on the amplifier, tape recorder, mixing board, and other
    necessary components of your audio system.  Set the volume control (or
    input level controls) to moderate settings.

3.  Set the receiver's volume control to its minimum setting.

4.  Press the receiver's power button to the on position.  The green power
    indicator lights.

5.  Set the receiver channel switch to the same channel as the transmitter

6.  Set the microphone's ON/STBY/OFF switch to ON.  The receiver's red
    READY indicator lights.

7.  Begin talking into the microphone and adjust the receiver's volume
    control to the desired level.

    Note: Experiment with the receiver's volume setting and the settings
          of other components in your audio system to obtain the best
          results.

Using The Standby Setting

The microphone's STBY setting lets you turn off the microphone without
turning off the microphone's transmitter.

If you move the switch from ON or STBY to OFF while your amplifier is on,
there is a loud pop.  There is no pop when you move the switch from STBY
to ON, or from ON to STBY.

To conserve battery power, be sure to set the switch to OFF when you 
finish using the microphone.

Low Battery Indications

The microphone's BATT LOW indicator tells you the condition of the battery

If the indicator flickers when you move the microphone's switch from OFF 
to STBY, the battery is good.

If the indicator lights when you are using the microphone (in the ON or 
STBY position), battery power is low and you should replace the battery.

CAUTION:  Never leave a weak or dead battery inside the microphone.  Even
          leak-proof batteries can leak damaging chemicals.

(GLW EB 8/14/00)

Privacy Policy