Electronic Reverb 320-1110A Audio connections

Electronic Reverb  (320-1110A) Line In/Line Out Jacks   Facback Doc. # 6997

1.  Connect the output of a tape player, turntable pre-amp, or other high
    -level source to the reverb's LINE IN jack.

2.  Connect the reverb's LINE OUT jack to the line input or auxiliary
    input of your receiver/amplifier or PA amplifier.

Use shielded audio cables with RCA-type plugs.  These are available at
your local Radio Shack store.

You can use LINE IN and MIC IN separately or together.  For example, you
can announce through the microphone input while playing recorded music
through the line input.  You can record from LINE OUT while using MIC OUT
live.

The DELAY, REPEAT, and DEPTH controls affect both the MIC OUT and LINE
OUT signals.  The MICROPHONE control adjusts the microphone signal level
in relation to the line signal level.  You can set the overall volume
level by using the controls on your receiver/amplifier or PA amplifier.


(smm 03/02/94)