MPA-30  (320-2034)            Vehicle Installation     Faxback Doc. # 6965
20-Watt AC/Mobile PA Amplifier

Before you install the amplifier in your vehicle, read the following hints
to help you select a proper mounting location:

*  Choose a mounting location in your vehicle where all the amplifier's
   controls are easy to reach but do not interfere with the operation of
   the vehicle.  The most common location is under the dashboard directly
   over the drive shaft hump.

*  Be sure all wires and cables are away from the brake, clutch, and
   accelerator.

*  Be sure the mounting location allows enough leg room for passengers.

*  Mount the amplifier so that you can easily remove it for service or
   maintenance.

*  Do not mount the amplifier in the air stream path of a heater or air
   conditioner.

After you select a mounting location, follow these steps to mount the
amplifier in your vehicle.

1.  Position the left and right mounting brackets on the desired mounting
    surface and mark the mounting holes.

2.  Use a drill with a 1/8-inch bit to drill holes on the marked location.

Caution:  Be careful not to drill into objects behind the mounting
          surface.

3.  Mount the brackets using the supplied bolts, washers and nuts, and
    self-tapping screws.

4.  Attach the amplifier to the brackets using the supplied thumb screws.


(smm 03/04/94)

Privacy Policy