8-Channel 170 MHz Portable Wireless PA System
(320-1245)                 Operation                  Faxback Doc. # 59905

Notes:  You can use a wireless and wired microphone at the same time. 

        Be sure to select the correct frequency channel for your PA system 
        to match your wireless microphone's operating frequency channel.

Using a Wireless Microphone

1.  Rotate WIRELESS MIC VOLUME counterclockwise to the minimum level (the
    smallest dot on the left side of the knob).

2.  Select the frequency channel on the PA system to match your
    microphone's operating frequency channel or channel combination by 
    setting the DIP switch located on the back of the PA system.

    For example, if your microphone frequency is A, use a sturdy pointed
    object (like a ball-point pen or finger nail file) to set each switch
    on the DIP to (down, down, up) as indicated by the operation channel
    combination table located on the back panel.  The "[]" represents the
    raised nub on each switch.

    Notes: Wireless microphones are sold in three channel combinations:
           AEH, BDG, and CFH.

           If you use two receivers in the same room with a separate
           wireless microphone assigned to each receiver, make sure the
           channels are not adjacent (follow in alphabetical sequence).
           For example, if one receiver is set to channel G and the other
           to H, it will create interference.  To remove the interference,
           set one receiver to H and the other to F.

3.  Set ON/OFF to ON.  POWER lights.

4.  Set the wireless microphone's ON/OFF switch to ON.  Ready lights.

5.  Rotate WIRELESS MIC VOLUME to the desired level.  (The larger the dot,
    the higher the level.)

6.  When you finish using the PA system, turn WIRELESS MIC VOLUME to the
    minimum position and set ON/OFF to OFF.

Using a Wired Microphone

1.  Connect the wired microphone to the amplifier's MIC jack located on
    the back of the amplifier.

2.  Rotate MIC VOLUME counterclockwise to the minimum level (the smallest
    dot on the left side of the knob).

3.  Set ON/OFF to ON.  POWER lights.

4.  Set the microphone's ON/OFF switch to ON.

5.  Rotate MIC VOLUME to the desired level.  (The larger the dot, the
    higher the level.)

6.  When you finish using the PA system, rotate MIC VOLUME to the minimum 
    position and set ON/OFF to OFF.

(BR EB 5/30/00)

Privacy Policy