8-Channel 170 MHz Portable Wireless PA System
(320-1245) Preparation Faxback Doc. # 59904
Using AC Power
You can power the PA system using the supplied AC cord.
CAUTIONS: The cord's plug must fit the system's ~120 VAC, 60 Hz, 60W Jack.
The supplied cord meets these specifications. Using a cord that
does not meet these specifications could damage the system or
the AC cord. You can order a replacement cord through your local
RadioShack store.
Always connect the AC cord to the system before you connect it
to the power source. When you finish, disconnect the DC cord
from the power source before you disconnect it from the system.
Set the amplifier to OFF. Plug the power cord's plug into the amplifier's
~120 VAC 60 Hz 60 W jack. Then plug the other end of the cord into a
standard AC outlet.
CAUTION: The supplied power cord has a polarized plug that fits into the
outlet only one way. If the plug does not fit properly, turn it
over and try again. Do not force it.
Using Vehicle Battery Power
You can power the PA system from a vehicle's 12V power source (such as a
cigarette-lighter socket) using the supplied DC cord.
CAUTIONS: You must use a power source that supplies 12 VDC and delivers
at least 2500 mA. Its plug must fit the system's DC 14.4 V/
2.5 A jack. The supplied adapter meets these specifications.
Using a cord that does not meet these specifications could
damage the system or the adapter.
Always connect the cord to the system before you connect it to
the power source. When you finish, disconnect the DC cord from
the power source before you disconnect it from the system.
Set the amplifier to OFF. Plug the DC power cord's barrel plug into the
14.4 VDC/2.5 A jack. Then plug the other end of the cord into a standard
DC source such as an automobile 12V accessory outlet.
(BR EB 5/30/00)
Privacy Policy