Unidirectional Dynamic Microphone
(330-3024)                 Operation                  Faxback Doc. # 59460

Note:  To prevent feedback, make sure the microphone's ON/OFF switch is
       set to OFF before connecting it to a PA or recording system.

1.  Plug the microphone's 1/4 inch (6.35 mm) plug into the microphone jack
    on your PA or recording system.

2.  Turn on your PA or recording system.

3.  Set ON/OFF to ON to turn on the microphone.  When you finish using the
    microphone, set ON/OFF to OFF.

Using the Microphone Holder

To use the supplied microphone holder with your microphone, screw it onto 
the top of a microphone stand (not supplied), then slide the microphone 
into the larger end of the holder.

Mounting on a Stand

Screw microphone holder onto stand in a clockwise motion.

(EB 4/24/00)

Privacy Policy