Optimus Unidirectional Dynamic Microphone
(330-3023)                 Operation                  Faxback Doc. # 56294

Note:  Be sure the microphone's ON/OFF switch is set to OFF before
       connecting it to a PA or recording system to prevent feedback.

1.  Plug your microphone's 3-pin (XLR) plug into the corresponding end of
    the supplied cord.

2.  Plug the cord's other end (a 1/4-inch [6.35 mm] plug) into the
    microphone jack of your PA or recording system.

3.  Turn on your PA or recording system.

4.  Set the microphone's ON/OFF switch to ON.  When you finish using the
    microphone, set ON/OFF to OFF.

Using the Microphone Holder

To use the supplied microphone holder with your microphone, screw it down, 
onto the top of a microphone stand.  Then slide the microphone into the 
larger end of the holder until it is secure.

(EB 8/11/99)