CD-3329 Portable Triple-Play CD Player w/AM/FM Stereo
(140-0507A)                Preparation                Faxback Doc. # 51815

Connecting The Speakers

CAUTION:  Do not plug in the power cord until you connect the speakers.  
Operating the CD-3329 without connected speakers could damage it.

The wires for the CD-3329's detachable speakers are rolled up in the 
recessed area at the back of each speaker.

Unwind the wire from each speaker then follow these steps to connect the 
speakers to the system.

1.  If you want to attach the speakers, align the dovetails on the side of
    the right speaker with the tracks on the right end of the main system
    and slide the speaker down until it clicks into place.

    Align the dovetails on the side of the left speaker with the tracks on
    the left end of the main system and slide the speaker down until it
    clicks into place.

2.  Press the red speaker terminal tab labeled (R +) on the back of the
    system, insert the stripped end of the right speaker's stripped wire
    into the terminal, then release the tab.

3.  Press the black speaker terminal tab labeled (R -) on the back of the
    system, insert the stripped end of the right speaker's other wire into
    the terminal, then release the tab.

4.  Repeat Steps 3 and 4 to connect the left speakers to the (L +) and
    (L -) terminals.

To disconnect the speakers from the system disconnect the speaker wires 
from the CD-3329.  Then (if speakers are attached) hold down the main 
system while you slide the speakers upward along the tracks.

Installing The Remote Control's Batteries

The remote control requires two AAA batteries (not supplied) for power.  
We recommend alkaline batteries, such as RadioShack Cat. No. 23-555.

CAUTIONS:  Use only fresh batteries of the required size and recommended
           type.

           Do not mix old and new batteries, different types of batteries
           (standard, alkaline, or rechargeable), or rechargeable
           batteries of different capacities.

Follow these steps to install batteries.

1.  Press the tab on the battery compartment cover and lift the cover to
    open it.

2.  Install the batteries as indicated by the polarity symbols (+) and (-)
    marked inside the compartment.

3.  Replace the cover.

Connecting Power

You can power your CD-3329 from either:

  Standard AC power (with the supplied power cord).

  eight D batteries (not supplied).

Note:  Connecting the power cord disconnects internal batteries.

Using AC Power

To use AC power, plug the supplied power cord into the AC ~ 120V jack on 
the back of the CD-3329.  Then plug the other end into a standard AC 
outlet.

CAUTIONS:  The plug's blades are polarized (one blade is wider than the
           other) and fit only one way.  If the plug will not fit easily,
           turn it over and try again.  Do not force it.

           Be sure the plug's blades are fully inserted to prevent blade
           exposure.

           Always unplug the power cord from the AC outlet before you
           unplug it from the CD-3329.

After you connect the power cord to the AC outlet, the POWER indicator 
lights if the switch is set to CD or RADIO.  But if it is set to TAPE, the 
indicator does not light until you play or record a tape.

Using Batteries

The CD-3329 can use eight D batteries (not supplied) for power.  We 
recommend alkaline batteries, such as Cat. No. 23-550.

CAUTIONS:  Use only fresh batteries of the required size and recommended
           type.

           Do not mix old and new batteries, different types of batteries
           (standard, alkaline, or rechargeable), or rechargeable
           batteries of different capacities.

Follow these steps to install batteries.

1.  Remove the battery compartment cover by pushing the cover's two tabs
    in the direction of the arrows.

2.  Insert the batteries as indicated by the polarity symbols (+ and -)
    marked above the battery compartment.

    Note:  For easy removal, place all eight batteries over the ribbon.

3.  Replace the cover.

Note:  If you do not plan to use the system for several days, or if you
       plan to power the system using AC power only, remove the batteries.

(EB 4/5/99)