CD-3327 Portable Triple Play Compact Disc Player
(140-0505A)                Preparation                Faxback Doc. # 51809

Connecting The Speakers

CAUTION:  Do not plug in the power cord or install batteries until you
          connect the speakers.  Operating the CD-3327 without connected
          speakers could damage it.

Follow these steps toe connect the speakers to the system.

1.  Align the dovetails on the side of the right speaker with the tracks
    on the right end of the main system and slide the speaker down until
    it clicks into place.

2.  Align the dovetails on the side of the left speaker with the tracks on
    the left end of the main system and slide the speaker down until it
    clicks into place.

3.  Plug the right speaker's connector into SPEAKER (R) and the left
    speaker's connector into SPEAKER (L) on the back of CD-3327.

To disconnect the speakers from the system, first unplug the speaker 
connectors from the CD-3327.  Hold down the main system while you press 
the tab on the back of each speaker in the direction of the arrow and
slide each speaker upward along the tracks.

Connecting Power

You can power your CD-3327 from either:

  Standard AC power (with the supplied power cord).

  Eight D batteries (not supplied).

Note:  Connecting the power cord disconnects internal batteries.

Using AC Power

To use AC power, plug the supplied power cord into the AC~ jack on the 
back of the CD-3327.  Then plug the other end into a standard AC outlet.

CAUTIONS:  The plug's blades are polarized (one blade is wider than the
           other) and fit only one way.  If the plug does not fit easily,
           turn it over and try again.  Do not force it.

           Always unplug the power cord from the AC outlet before you
           unplug it from the CD-3327.

Using Batteries

You can use eight D batteries (not supplied) to power the CE-3327.  For 
the best performance and longest life, we recommend alkaline batteries, 
such as RadioShack Cat. No. 23-550 and 23-650.

CAUTIONS:  Use only fresh batteries of the required size and recommended
           type.

           Do not mix old and new batteries, different types of batteries
           (standard, alkaline, or rechargeable), or rechargeable
           batteries of different capacities.

Follow these steps to install batteries.

1.  Remove the battery compartment cover by pushing the cover's tab
    downward and lifting off the cover.

2.  Put eight D batteries in the battery compartment as indicated by the
    polarity symbols (+ and -) marked inside.

3.  Replace the cover and snap it shut.

When the sound weakens or the CD-3327 stops operating properly, replace 
all eight batteries.

CAUTIONS:  Always remove old or weak batteries.  Batteries can leak
           chemicals that can destroy electronic parts.

           If you do not plan to use the CD-3327 with batteries for
           several weeks, or if you plan to power the CD-3327 using AC
           power only, remove the batteries.

Using Headphones

For private listening, plug a pair of optional stereo headphones with a 
1/8-inch (3.5 mm) plug into the (headphones symbol) PHONES jack.  Your 
local RadioShack store has a wide selection of headphones.

Listening Safely

To protect your hearing, follow these guidelines when you use headphones.

  Set the volume to its lowest setting before you begin listening.  After
  you begin listening, adjust the volume to a comfortable listening level.

  Do not listen at extremely high volume levels.  Extended high-volume
  listening can lead to permanent hearing loss.

  Once you set the volume, do not increase it.  Over time your ears adapt
  to the listening level, so a volume level that does not cause discomfort
  might still damage your hearing.

(EB 4/5/99)