CD-3321 Portable Triple-Play Compact Disc Player w/AM/FM
(140-0546A) Preparation Faxback Doc. # 49436
CONNECTING THE SPEAKERS
CAUTION: Do not plug in the power cord until you connect the speakers.
Operating the CD-3321 without connected speakers could damage
it.
The connecting wires for the CD-3321's detachable speakers are rolled up
in the recessed area at the back of each speaker.
Follow these steps to connect the speakers to the system.
Note: The right speaker has the tracks on its left side when viewed from
the front. The left speaker has the tracks on its right side when
viewed from the front.
1. Align the tracks on the side of the right speaker with the tracks on
the right end of the main system and slide the speaker down until it
clicks into place.
2. Align the tracks on the side of the left speaker with the tracks on
the left end of the main system and slide the speaker down until it
clicks into place.
3. Unwind the wire from each speaker.
4. Press the pair of terminal tabs marked Speakers 8 Ohms/+R- on the back
of the CD-3321. Insert the right speaker's red wire into the red (+)
terminal and its black wire into the black (-) terminal. Then release
the tabs.
CAUTION: To avoid damaging your system and speakers, never let the
speaker wires' bare ends touch each other.
5. Repeat Step 3 to connect the left speaker's wires to the terminals
marked SPEAKERS 8 Ohms/-L+.
To disconnect the speakers from the system, first disconnect the speaker
wires from the CD-3321. Then push in the mounting tabs on the sides of
the main system and slide the speakers upward along the tracks.
CONNECTING POWER
You can power your CD-3321 from any of three power sources:
Internal batteries.
Standard AC power (with the supplied power cord).
Your vehicle's cigarette-lighter socket (with an optional DC adapter).
Note: Connecting the power cord or an optional DC adapter disconnects the
internal batteries.
Using Batteries
You need eight D batteries (not supplied) to power the CD-3321. We
recommend alkaline batteries, such as RadioShack Cat. No. 23-550.
CAUTIONS: Use only fresh batteries of the required size and recommended
type.
Do not mix old and new batteries or different types of
batteries.
Follow these steps to install batteries.
1. Remove the battery compartment cover by pushing the cover's two tabs
in the direction of the arrows.
2. Insert eight D batteries as indicated by the polarity symbols (+ and
-) marked inside the battery compartment.
3. Replace the cover.
When the CD-3321 operates erratically or not at all, replace the
batteries.
CAUTIONS: Always remove old or weak batteries. Batteries can leak
chemicals that can destroy electronic parts.
Dispose of old batteries promptly and properly. Do not burn or
bury them.
Note: If you do not plan to use the system for several days, or if you
plan to power the system using only AC or DC power, remove the
batteries.
Using AC Power
To use AC power, plug the supplied power cord into the AC 120V 60 Hz jack
on the back of the CD-3321. Then plug the cord's other end into a
standard AC outlet.
Note: The plug's blades are polarized (one blade is wider than the other)
and it fits only one way. If the plug will not fit easily, turn it
over and try again. Do not force it.
CAUTION: Always unplug the power cord from the AC outlet before you
unplug it from the CD-3321.
Using Your Vehicle's Cigarette-Lighter Socket
To power the CD-3321 from your vehicle's cigarette-lighter socket, you
need a DC adapter (not supplied), such as Cat. No. 270-1528.
Cautions: You must use a DC cigarette-lighter adapter that supplies 12
volts and delivers at least 1 amp. Its center tip must be set
to positive, and its plug must correctly fit the CD-3321's DC
12V jack. The recommended adapter meets these specifications.
Using an adapter that does not meet these specifications could
damage the CD-3321 or the adapter.
Unplug the adapter from your vehicle's cigarette-lighter socket
when you turn off the ignition. This prevents your vehicle's
battery from being drained if you leave the CD-3321 on when you
turn off the ignition.
Always plug the DC adapter into the CD-3321 before you plug it
into your vehicle's cigarette-lighter socket, and unplug the
adapter from your vehicle's cigarette-lighter socket before you
unplug its barrel plug from the CD-3321.
Insert the DC adapter's 5.5 outer diameter/2.1 inner diameter barrel plug
into the DC 12V jack on the back of the CD-3321, then plug the DC adapter
into your vehicle's cigarette-lighter socket.
Note: If the CD-3321 does not operate when you turn it on, remove the DC
adapter from your vehicle's cigarette-lighter socket and check the
socket for debris. Also, check the fuse in the adapter and your
vehicle's fuse block.
(BR/eb 8/26/98)
Privacy Policy