CFD-567 CD Radio Cassette-Corder
(140-0501) Preparation Faxback Doc. # 46667
THE TIMER
SETTING THE CLOCK
Before you set the clock, insert four size AA (R6) batteries and connect
the AC power cord (see below.) As long as the clock goes, ":" flashes.
1. Press and hold CLOCK for about two seconds until "AM" or "PM" and the
hour digit flash.
2. Press TIME SET +/- until you set the current hour. Then press
DISPLAY/ENTER/MEM.
The minute digits flash. Set the minutes by pressing TIMER SET +/-
until the current minute is displayed.
3. Press DISPLAY/ENTER/MEM.
The clock starts from 00 seconds.
Tip
The time display system of this player is the 12 hour system:
AM 12:00 = midnight
PM 12:00 = noon
SETTING UP
HOOKING UP THE SYSTEM
Make sure you turn off the power before making any connections.
Tips
To detach the speakers, unlock speaker and slide the speaker box all
the way up and away from the player.
Connect the speakers for this unit on to the speaker terminals of this
unit. If you connect any other speaker or equipment, malfunction may
occur.
1. Inserting The Back Up Batteries
Insert four size AA batteries (not supplied) into the battery
compartment. These batteries work to save the memory data.
Notes: When you operate the player with the batteries, you cannot turn
on the player using the remote.
When you operate the player with batteries, the backlight does
not work even if the player is on.
2. Hooking Up The Speakers
A. Align the grooves and slide the speaker box down until it snaps
into place.
B. Twist the speaker cable coating and strip it from the end of the
cable.
C. Connect the black wires to (-) minus and the red wires to (+) plus
terminals; the right speaker wires to the R and the left speaker
wires to the L terminals.
3. Connecting The Ac Power Cord
Insert one end of the supplied AC power cord to the AC IN socket
located at the rear of the player, and the other end to the wall
outlet.
4. Inserting Batteries Into The Remote
Insert two size AA batteries (not supplied)
Replacing Batteries
With normal use, the batteries should last for about six months. When
the remote no longer operates the player, replace all the batteries
with new ones.
5. Using The Player On Batteries
Insert eight size D batteries (not supplied) into the battery
compartment.
To use the player on batteries, disconnect the AC power cord from the
player.
Tip
Replace the batteries when the OPR/BATT indicator dims or when the
player stops operating. Replace all the batteries with new ones.
Before you replace the batteries, be sure to take out the CD from the
player.
ADJUSTING THE AUDIO EMPHASIS (MEGA BASS/ROTARY EQUALIZER/SURROUND)
You can adjust the audio emphasis of the sound you are listening to.
SELECTING THE SOUND CHARACTERISTIC
Turn MEGA BASS/ROTARY EQUALIZER to select the audio emphasis you want.
Frequency Turn the control Turn the control counterclockwise
coverage: clockwise (to + 10) (to - 10)
MEGA BASS to increase heavy to decrease heavy bass sounds
100 Hz bass sounds
400 Hz to emphasize to de-emphasize speaking voice.
speaking voice, middle frequencies of instrumental
middle frequencies music.
of instrumental
music.
1 kHz To provide more to provide less presence of vocals
presence of
vocals
4 kHz to heighten overall to lessen overall brightness of
brightness of sound sound
10 kHz to increase high to decrease high treble sounds or
treble sounds reduce high frequency noise/tape hiss
GETTING THE SURROUND EFFECT (CFD-567 ONLY)
Press SURROUND.
The "SURROUND" indication appears in the display.
You can get the surround effect without connecting surround speakers.
(BR/tc 04/16/98)
Privacy Policy