SSM-50 2-Channel Stereo DJ Mixer
(320-3005)                 Troubleshooting            Faxback Doc. # 40123


With proper care and handling, your mixer should give you years of trouble-
free service.  However, if your SSM-50 is not working properly, follow
these suggestions to see if you can eliminate the problem.  If you still
have a problem, take the mixer to your local RadioShack store for 
assistance.

Problem                      Possible Solution

Nothing works                Check the AC power connection and make sure
                             the AC outlet is "live."

                             Check all the connections to the system
                             (amplifier/receiver, input sources, and so on).

The signal from an audio     Make sure the MIC OFF/ON/TALKOVER switch is
input source is too low.     not set to TALKOVER.

                             Check the mixer's and the source's control
                             settings.

No signal from an audio      Check the mixer's and the source's control
input source.                settings.

                             Check the connection between the mixer and the
                             input source.

Hum from PHONO sources       Be sure the turntable's ground wire (usually
                             black or green) is connected to the GND screw
                             on the back of the mixer.

Hum from other input         Make sure there are no low-level inputs
sources                      connected to the LINE 1 and LINE 2 jacks.

Feedback "squeals"           Move the microphone further away from the
                             output speakers or use a directional
                             microphone.

(km-06/19/1997)

Privacy Policy