900 MHz Wireless Speakers
(400-1372)                 Preparation                Faxback Doc. # 37912


INSTALLING THE TRANSMITTER

CONNECTING TO YOUR AUDIO SOURCE

You can connect the transmitter to your audio source's left and right audio
output jacks or its headphones jack.

CAUTION:  Do not connect the transmitter to the audio source's speaker
          output.  Doing so could damage the transmitter and audio source.

1.  Connect one end of the supplied audio patch cord to the transmitter's
    AUDIO IN jacks (white plug to L and red plug to R).

2.  If you are using your audio source's audio output jacks, connect the
    white and red plugs at the other end of the patch cord directly to the
    audio source's corresponding left and right audio jacks (white plug to
    left and red plug to right).

    If you are using your audio source's stereo headphones jack, connect
    the white and red plugs at the other end of the patch cord to the white
    and red phono jacks on the supplied Y-cable.

    If your audio source has a 1/8-inch headphones jack, connect the 1/8-
    inch stereo plug on the other end of the Y-cable directly to the audio
    source's 1/8-inch headphones jack.

    NOTE:  If your audio source has a 1/4-inch headphones jack, use the
           supplied 1/8-to-1/4-inch stereo adapter.


CONNECTING TO POWER

Plug the supplied AC adapter's small straight barrel plug into the
transmitter's DC 18V jack.  Then plug the adapter into a standard AC
outlet.

CAUTIONS:

     The transmitter's supplied AC adapter (in a box marked FOR
     TRANSMITTER) provides 18 volts and at least 150 milliamps, and its
     plug's center tip is positive.  Using an adapter that does not meet
     these specifications could damage the adapter or the transmitter.

     The CHARGER jack on the transmitter is for charging the RadioShack
     PRO-100 Wireless Headphones (Cat. No. 33-1145).  Do not plug any other
     device into this jack.


INSTALLING THE SPEAKERS

Select a location for each speaker that is near an AC outlet.

CAUTION:  Each speaker's supplied AC adapter (in a box marked FOR SPEAKER)
          provides 15 volts and at least 800 milliamps, and its plug's
          center tip is positive.  Using an adapter that does not meet
          these specifications could damage the adapter or the speaker.

Follow these steps to install the speakers.

1.  Turn off both speakers by rotating their POWER/VOL knobs fully
    counterclockwise until they click.

2.  Set each speaker's mode switch as follows:

     L - For the left stereo speaker
     R - For the right stereo speaker
     MONO - If your source is mono

3.  Plug the AC adapter's large right-angle barrel plug into the speaker's
    DC 15V 800 mA jack.

4.  Plug the AC adapter into a standard AC outlet.

(YO/km-02/06/1997)

Privacy Policy