Portable CD Player
(140-0546)                  Preparation                Faxback Doc. #36951


PREPARATION

CONNECTING THE SPEAKERS

CAUTION:  Do not plug in the power cord until you connect the speakers. 
          Operating the CD-3321 without connected speakers could damage
          it.

The connecting wires for the CD-3321's detachable speakers are rolled up
in the recessed area at the back of each speaker.

Follow these steps to connect the speakers to the system.

NOTE:  The right speaker has the tracks on its left side when viewed from
       the front.  The left speaker has the tracks on its right side when
       viewed from the front.

1.   Align the dovetails on the side of the right speaker with the tracks
     on the right end of the main system and slide the speaker down until
     it clicks into place.

2.   Align the dovetails on the side of the left speaker with the tracks
     on the left end of the main system and slide the speaker down until
     it clicks into place.

3.   Press the pair of terminals tabs marked SPEAKERS 8 Ohms/+R- on the
     back of the CD-3321.  Insert the right speaker's red wire into the
     red (+) terminal and its black wire into the black (-) terminal. 
     Then release the tabs.

     CAUTION:  To avoid damaging your system and speakers, never let the
               speaker wires' bare ends touch each other.

4.   Repeat Step 1 to connect the left speaker's wires to the terminals
     marked SPEAKERS 8 ohms/-L+.

To disconnect the speakers from the system, first disconnect the speaker
wires from the CD-3321.  Then press and hold down the mounting clips on
the sides of the main system and slide the speakers upward along the
tracks.

(YO/rg 12/2/96)

Privacy Policy