Electronic Reverb 320-1110B Connections

Electronic Reverb
(320-1110B)                 Connections               Faxback Doc. # 31998

LINE IN/LINE OUT JACKS

1.  Connect the output of a tape player, turntable pre-amp, or other
    source to the Reverb's LINE IN jack.

2.  Connect the Reverb's LINE OUT jack to the line input or auxiliary
    input of the receiver/amplifier or PA amplifier.  Use shielded cables
    with RCA plugs.  You can use LINE IN or MIC IN separately or together.

MIC IN/MIC OUT JACKS

1.  Connect a microphone's 1/4 inch phone plug to the MIC IN jack on the
    Reverb.

2.  Connect the 1/4 inch phone plug of a shielded audio cable to the
    Reverb's MIC OUT jack.

3.  Connect the other end of the audio cable to the mic input of the
    receiver/amplifier or PA amplifier.

CONNECTING AN ELECTRONIC INSTRUMENT

1.  Connect the instrument's output to the MIC IN jack on the Reverb.

2.  Using a shielded audio cable, connect the Reverb's MIC OUT jack to the
    mic input of the receiver/ amplifier.


(IR-02/21/96)