CD Radio Cassette-Corder
(140-0544) Operation Faxback Doc. # 19552
PLAYING A CD
For hookup instructions, see Faxback Doc. # 19556, Setting Up.
1. Press /\ OPEN/CLOSE (direct power-on) and place the disc on the disc
tray (with the label side up). Be sure to align the center of the CD
with the center of the disc tray.
NOTES: You can't play 3 inch (8 cm) CDs even with an adaptor for
single-CDs.
Place one CD only on the disc tray. If you place two or three
CDs and close the disc tray, you will not be able to pull out
the tray. (See "Playing multiples discs," Faxback Doc. #
19553, The CD Player.
2. Press >||.
The disc tray closes and the player plays all the tracks once.
TIPS: If "ALL DISCS" lights up, the player plays other CDs in numerical
sequence. To play only one CD, press DISC MODE to select "1 DISC."
Next time you want to listen to a CD, just press >||. The player
turns on automatically and starts playing the CD.
Use These Buttons For Additional Operations
To Press
_______________________________________________________________________
Adjust the volume VOLUME +/-
_______________________________________________________________________
Stop playback (Button with a square)
_______________________________________________________________________
Pause playback >||
Press again to resume play after
pause.
_______________________________________________________________________
Go to the next track >>| AMS/SEARCH
_______________________________________________________________________
Go back to the previous track |<< AMS/SEARCH
_______________________________________________________________________
Remove the CD /\ OPEN/CLOSE
_______________________________________________________________________
Turn on/off the player POWER
_______________________________________________________________________
LISTENING TO THE RADIO
For hookup instructions, see Faxback Doc. # 19556, Setting Up.
1. Press BAND until the band you want appears in the display (direct
power-on).
2. Hold down TUNING+ until the frequency digits begin to change in the
display.
The player automatically scans the radio frequencies and stops when
it finds a clear station.
If you can't tune in a station, press the button one at a time.
TIPS: If the FM broadcast is noisy, press PLAY MODE/MONO/ST until "Mono"
appears in the display and the radio will play in monaural.
Next time you want to listen to the radio, just press the BAND
button. The player turns on automatically and starts playing the
previous station.
Use These Buttons For Additional Operations
To Press
___________________________________________
Adjust the volume VOLUME +/-
___________________________________________
Turn on/off the radio POWER
___________________________________________
To Improve Broadcast Reception
Reorient the antenna for FM. Reorient the player itself for AM.
PLAYING A TAPE
For hookup instructions, see Faxback Doc. # 19556, Setup.
1. Press STOP/EJECT to open the tape compartment and insert a recorded
tape (With the side you want to play facing up). Use TYPE I (normal)
tape only. Close the compartment.
2. Press >.
The player turns on (direct power-on) and starts playing.
TIP: Next time you want to listen to a tape, just press >. The player
turns on automatically and starts playing the tape.
Use These Buttons For Additional Operations
To Press
_______________________________________________________________
Adjust the volume VOLUME +/-
_______________________________________________________________
Stop playback STOP/EJECT
_______________________________________________________________
Fast-forward or rewind the tape >> or <<*
_______________________________________________________________
Pause playback ||
Press the button again to
resume play after pause.
_______________________________________________________________
Eject the cassette STOP/EJECT
_______________________________________________________________
Turn on/off the player POWER
_______________________________________________________________
* After winding the tape with >> or <<, press STOP/EJECT to release it.
RECORDING ON A TAPE
For hookup instructions, see Faxback Doc. # 19556, Setting Up.
1. Press STOP/EJECT to open the tape compartment and insert a blank tape
(with the side you want to record on facing up). Use TYPE 1 (normal)
tape only.
2. Select the program source you want to record.
To record from the CD player, insert a CD (see above) and press STOP
PLAYBACK on the CD section.
To record from the radio, press BAND and tune in the station you want
(see above.)
3. Press REC to start recording. (> is depressed automatically.)
TIPS: Adjusting the volume or the audio emphasis will not affect the
recording level.
For the best results, use the AC power source as a power source.
If the AM program makes a whistling sound after you've pressed REC
in step 3, set the ISS (Interference Suppress Switch) at the rear to
the position that most decreases the noise. Normally set the switch
to "2."
To record from discs at the average recording level, press A. AGC
before starting recording. Do not press A. AGC during recording.
To erase a recording, proceed as follows:
1. Disconnect the microphone if connected at the MIX MIC jack.
2. Turn on the power and then press FUNCTION until "TAPE" appears in the
display window.
3. Press REC.
(CS 2/26/96)
Privacy Policy