PRO X77 Speaker  (400-2072/77)       Connections       Faxback Doc. # 16118

With the speakers placed in their approximate locations, measure the
distance from each speaker to your receiver/amplifier.

Use 18-gauge speaker wire for distances of 50 feet or less.  For distances
greater than 50 feet, use heavier 16-gauge wire.

NOTE:  For maximum bass response and the best overall performance, connect
       your speakers so they are in phase with each other (+ with +, - with
       -).  You can easily make the proper connections with coded speaker
       wire available at your local Radio Shack store.

1.  Separate the wire's two conductors at both ends for a length of about 4
   inches.

2.  Strip the insulation from the ends of each conductor to expose 1/4-inch
    of metal wire.

3.  Press the tab on the left speaker's negative (-) terminal and insert
    one of the wire ends.  Then release the tab.

4.  Press the tab on the left speaker's positive (+) terminal and insert
    the other wire end.  Then release the tab.

5.  Using the speaker's wire code as a guide, connect the left speaker's
    negative (-) terminal to the receiver/amplifier's left negative (-)
    terminal.

    Then connect the left speaker's positive (+) terminal to the receiver/
    amplifier's left positive (+) terminal.

6.  Repeat steps 3-5 to connect the right speaker.


(ALL-07/25/95)

Privacy Policy