AMX 20 Wireless Speakers (400-1364) Troubleshooting Faxback Doc. # 15849
If you follow all the instructions, you should have no problems with your
AMX 20. However, if you do have a problem, check the following table for
a solution.
---------------------------------------------------------------------------
| Problem | Solution |
---------------------------------------------------------------------------
| No Sound. | Be sure the speakers are turned on. |
| | |
| | Be sure the AC adapters are plugged in and have |
| | power. |
| | |
| | Be sure the audio source is turned on and |
| | operating. |
| | |
| | If you have connected to jacks that are controlled|
| | by the audio source's volume control, be sure the |
| | source's volume control is turned up - to 1/3 |
| | volume. |
| | |
| | Adjust the speaker's volume control to midway. |
| | |
| | Adjust TUNING on the speakers until LED lights. |
| | |
| | Change the position of the transmitter. |
---------------------------------------------------------------------------
| Distorted Audio. | Adjust TUNING. |
| | |
| | Change the position of the transmitter. |
| | |
| | Rotate FREQ ADJUST on the transmitter and then |
| | adjust TUNING until the interference goes away. |
| | |
| | Adjust LEVEL on the transmitter so the LEVEL |
| | indicator only flickers occasionally. |
---------------------------------------------------------------------------
Privacy Policy