MPA-45  (320-2035)             Connections             Faxback Doc. # 15122

CONNECTING MICROPHONES

Use the MIC 1 and MIC 2 jacks to connect one or two microphones to the 
amplifier.  The microphone(s) can be high- or low- impedance and must have
a 1/4-inch-6.35mm plug.

CONNECTING A TURNTABLE

Connect a turntable to the amplifier's L and R PHONO jacks.

Connect your turntable's ground wire (usually black or green) to the 
amplifier's GND screw to void hum.

CONNECTING AN AUXILIARY SOUND SOURCE

Connect an auxiliary sound source, such as a tape deck or a tuner, to the 
amplifier's L and R AUX jacks.

CONNECTING POWER

You can power your amplifier from standard household AC power.  To connect
the amplifier to power, plug the supplied AC cord into any standard outlet.

Your amplifier's fuse (located on the amplifier's back panel) protects your
amplifier from voltage surges.  If the power indicator does not light when
you press POWER, check the fuse.  If the fuse is blown, replace it with the
supplied spare fuse or an identical 1-amp, 250-volt fuse (CA: 2-amp, 250-
volt fuse).  Be sure you unplug the power cord before you replace the fuse.

To replace the amplifier's fuse, use a Phillips-head screwdriver to unscrew
the fuse holder.  Then, remove the fuse holder, replace the fuse, and
replace the fuse holder.


(SP/all-06/28/95)

Privacy Policy