VGM-340  (25-4047)                 Setup               Faxback Doc. # 6049

Follow these steps to connect the monitor to your computer and to power.

1. Be sure that power to all components is off.

2. Plug the monitor signal cable's matching connector into the SIGNAL INPUT
   terminal. Then plug the monitor signal cable's other connector into the   
   video port of a compatible computer.

CAUTION: Improperly connecting the cable could damage the monitor or 
computer.

3. Plug the monitor's power cord into the monitor's POWER INPUT jack. Then,
   plug the power cord into a standard, grounded AC outlet or approved
   power strip.

4. Before you turn on the monitor, check your computer's owner's manual for
   any instructions about turning on equipment connected to the computer.

5. Turn on the monitor.

NOTE: If horizontal lines appear on the screen, turn off the computer. Be 
sure the signal connector is firmly connected, and turn on the computer 
again.  

Installing the Stand:

CAUTION: Before you install the stand, be sure the monitor's power cord is
unplugged.

1. Turn the monitor upside down with the screen facing you.

2. Turn the stand upside down and place it on the monitor.

3. Insert the four stand-tabs into the four slots on the bottom of
   monitor's chassis.

4. Push down the stand. Then pull the stand toward you until it snaps into
   place. Turn the monitor and the stand upright.

Setup Hints:

* Do not obstruct the ventilation openings.
* Install the monitor the ventilation openings.
* Install the monitor at least 4" from any wall.
* Never place the monitor near or over a radiator or heat register.
* Never block the ventilation openings on the bottom of the monitor by
  placing it on a bed, sofa, rug, or other soft surface.
* Place the monitor in a built-in enclosure only if proper ventilation is
  provided.
* Keep the monitor dry and free of excess dust. Moisture and dust can
  damage the monitor.

Privacy Policy