LP 2  (26-1154A)                Cables                 Faxback Doc. # 5927

Model I without Expansion Interface to Line printer II or IV : 26-1416
Model I with Expansion Interface to Line printer II or IV    : 26-1415

Model II to Line printer II or IV : 26-4402

Model III to Line printer II or IV : 26-1415

1. Be sure a ribbon is installed in the printer and that an adequate supp-
   ly of paper has been installed.

2. Connect 40-pin edge connector at the rear of the printer to TRS-80
   printer port on the Model I Expansion Interface or Model III. Use 6-foot
   ribbon cable 26-1415 for Model I and use 26-4402 for Model III.

3. Place the ONLINE/OFFLINE switch of OFFLINE position. This prevents the 
   printer from printing.

4. Connect power cord to 115 VAC outlet.

5. Place POWER switch to ON position. "Power On" LED should be visible
   through top cover paper opening.

6. Place ONLINE/OFFLINE switch to ONLINE position. Printer is ready to
   accept data.

You can also use the Printer Interface Cable, 26-1416, to connect directly
to the TRS-80 Model I.

(dkh-08/04/93)

Privacy Policy