LP 5  (260-1165)                   Cables              Faxback Doc. # 5666

COMPUTER           CABLE CATALOG NUMBER

Model I/III        26-1401
Model II           26-4401

Turn Printer and Computer OFF.

1. Install the cable for connection to Computer. Make sure that one end is
   provided with molded male plug. Insert this into connector in the rear 
   of the Printer. Do not force the plug, If it won't go on one way, turn 
   it over and try again.

2. Connect the other end of the cable to the Computer. If the Computer is 
   a TRS-80 Model I, make the connection to Line Printer Edge Card Con-
   nector of the Expansion Interface. For a Model III connect to the Line 
   Printer connection on the bottom. If it is a Model II, use the connector
   on the lower back of the computer.

You may also use the "active" interface cable, 26-1411, connected directly
to the 40-pin bus of the Model I, eliminating the need for the Expansion
Interface.

(dtc-08/04/93)

Privacy Policy