Tandy CGP-115 260-1192 Settings

CGP-115  (260-1192)            Dip Switches           Faxback Doc. # 5640

SETTING THE PRINT PARAMETERS

The settings of the DIP Switch (on the rear panel) of the Graphic Printer
determine how the Printer will print. They must also be appropriately
adjusted for the Computer that the Printer is connected to.

                        ----------------------
                        | ------             |
Parallel Printer    1.  | |    |             |        Serial Printer
                        | ------             |
                        | ------             |
80 Characters       2.  | |    |             |        40 Characters
Per Line                | ------             |        Per Line
                        |             ------ |
Carriage Return     3.  |             |    | |        Carriage Return
Only                    |             ------ |        and Line Feed
                        |             ------ |
Special             4.  |             |    | |        7-Bit ASCII
Characters              |             ------ |
                        ----------------------

Set each Switch to either right or left using a tool such as a pencil point
or ball-point pen with the pen-point retracted.

For instance, if you're using a TRS-80 Color Computer and the Computer is
connected to the Printer via the SERIAL I/O Jack, set DIP Switch #1 to the
right (Serial Printer).

Or, if you're in Text Mode (see Text Mode vs. Graphic Mode), and you want 
to print 80 characters per line (small print), set DIP Switch #2 to the 
left.

(dtc/tmc-06/14/95)