CGP-115  (260-1192)                Cables              Faxback Doc. # 5633

------------------------------------------------------------------
|COMPUTER                            | CABLE CATALOG NUMBER      |
------------------------------------------------------------------
|Model I/III/4                       | 26-1401                   |
|Model II/16/DT-1/6000               | 26-4401                   |
|Color Computer                      | 26-3020                   |
|Tandy 1000 Series (Not RL or TL/3)  | 26-225/26-222 (6'/12')    |
|All Others PC-Compatibles           | 26-227/26-223 (6'/12')    |
------------------------------------------------------------------
This printer has a Tandy parallel port.

POWER SUPPLY CONNECTIONS

Do not attempt to operate the Color Graphic Printer with any power supply
other than the supplied one!

1. Connect the AC Adapter to a wall outlet.
2. Then connect the power cable from the AC Adapter to the Color Graphic
   Printer's power supply AC ADPT jack.

CONNECTING THE COLOR GRAPHIC PRINTER TO A COMPUTER

When connecting the Color Graphic Printer to a TRS-80, be sure to use the
correct cable. The following table lists the correct cable to use with your
TRS-80. See your Computer owner's manual for complete details on connecting
printers.

1. Connect one end of the appropriate cable to the Color Graphic Printer.

If you're using a Color Computer, connect one end of the DIN cable to the
round, 4-pin SERIAL I/O Jack on the rear panel of the Printer.

If you're using a Model I/II/III/16 or DT-1, connect the cable connector to
the PARALLEL I/O Jack on the rear panel of the Printer.

2. Connect the other end of the cable to the TRS-80.

NOTE: Only one Printer Jack should have a cable connected to it at a time.
That is, if you have a cable connected to the PARALLEL I/O Jack, do not 
have a cable connected to the SERIAL I/O Jack (and vice versa).

(dtc-08/04/93)

Privacy Policy