Compaq Presario V410e Monitor
(250-0600)        Installing the Base Pedestal        Faxback Doc. # 47007

To install the base pedestal, foll the steps below:

1.  Turn the monitor upside down.

2.  Position the base pedestal with the latch facing the back of the
    monitor.

3.  Insert the six tabs on the base pedestal into the six slots found on
    the bottom of on the monitor.

4.  Push the base pedestal toward the front of the monitor until it snaps
    into position.

NOTE:  To remove the base pedestal, raise the latch, pull back, and lift
off.

(smm -- 04/03/98)