CM-8  (260-3215)               Installation            Faxback Doc. # 4846

SETTING UP THE CM-8

To set up the CM-8, you only have to connect the monitor to your Color 
Computer 3 via cable.

CONNECTING TO A COMPUTER

1. Be sure that the power to all components is OFF.

2. Connect the RGB connector to the computer's RGB interface on the bottom 
   of the computer.

3. Route the connector cable through the groove on the bottom of the 
   computer.

After you have connected the C-8 to your Color Computer, connect the CM-8's
AC cord to the power source.

Power up the CM-8 (and other peripherals if necessary), then the Color 
Computer 3.

After powering up, you may need to adjust the display of the CM-8

(dtc-07/27/93)

Privacy Policy