CM-5  (250-1023)                    Setup              Faxback Doc. # 4841

To set up the CM-5, you only have to connect the monitor to a compatible
computer via cable.

CONNECTING TO A COMPUTER

1. Be sure that all power to all components is OFF.
2. Connect the RGB connector to the computer's RGB interface.

After you have connected the CM-5 to a compatible computer, connect the 
CM-5's AC cord to the power source.

USING THE CM-5

Power up all equipment. Use your system owner's manual for instructions on
powering your computer and other peripherals.

After powering up, you may need to adjust the display of the CM-5.

ADJUSTING THE DISPLAY

The 5 display adjustment knobs are located below the video screen on the 
left side behind the control panel. The panel door swings down when it is 
gently pulled forward at its left-most corner.

V-HOLD--This control stabilizes the display on the screen. Rotate the knob
fully counterclockwise and then slowly until the display is stable.

V-SIZE--This control sets vertical size.

H-CENTER--This control sets horizontal position. Rotate the knob to center 
the display.

CONTRAST AND BRIGHTNESS--Adjust the screen brightness to compensate for 
room lighting.

* If the room is dark, rotate either or both of these controls
  counterclockwise until the picture is easily visible.

* If the room is bright, rotate either or both of these controls clockwise
  until the picture is easily visible.

* The CONTRAST control also adjusts the separation of low and high
  intensity characters--low or high as required.

(dtc-07/27/93)

Privacy Policy