DWP 2  (260-1158)               Self-Test              Faxback Doc. # 4651

Plug the AC cord into the AC Connector on the back of the Printer. Plug the 
other end into a 3-prong, grounded AC outlet.

Before connecting the Printer to the Computer (or Interface), perform the 
Printer Self-Test.

1. Turn the Printer on. The power switch is located on the rear of the unit
   just above the AC Connector.

NOTE: Do not perform the Self-Test unless the Printer is loaded with full 
size paper. Otherwise characters will be printed on the platen.

2. Set to OFF LINE on the control panel.

3. Press the TEST switch. It is on the rear above the interface connector. 
   the Printer should print a line of test characters.

4. Adjust Copy Control and/or Impression Control for best printing quality.

5. Turn off the Printer.

Now you've finished the Self-Test. Connect the Interface Cable to the jack 
on the back of the Printer. Connect the other end to the TRS-80 system.


(smm 07/27/93)

Privacy Policy