DMP 2120 (260-2811) Control Codes Faxback Doc. # 4612
IBM CONTROL CODES
00 Null
07 Sounds the Buzzer for one second
08 Backspace
09 Horizontal Tab
10 Line Feed
11 Vertical Tab (will be changed to Line Feed)
12 Form Feed
13 Carriage Return
14 Double Width On
15 Compressed
18 Select 10 CPI
20 Double Width Off
24 Cancel
27,14 Double Width On
27,15 Compressed
27,45,n Underline Start/End
27,48 1/8" Line Feed
27,49 1/10" Line Feed
27,50 Start Variable Line Feed
27,51,n Variable Line Feed
27,52 Set Top of Form
27,53,n Auto LF ON/OFF
27,54 Select Character Set 2
27,55 Select Character Set 1
27,56 Ignore Paper End
27,57 Cancel Ignore Paper End
27,58 Select 12 CPI
27,60 Home Head
27,65,n Set Variable Line Feed
27,67,n Set Lines Per Page
27,67,00,m Set Inches Per Page
27,68,n1,n2,...nk,00 Set Horizontal Tab Stops
27,69 Emphasized
27,70 Emphasized Off
27,71 Double Strike
27,72 Double Strike Off
27,73,n Font Select
27,74,n Execute Variable Line Feed
27,75,n1,n2,d1,d2,d3,... 60 DPI Image Graphics Mode
27,76,n1,n2,d1,d2,d3,... 120 DPI Image Graphics Mode
27,78,n Set Skip Perforation
27,79 Cancel Skip Perforation
27,80,n Proportional Spacing Off
27,82 Reset All Tabs
27,83,n Subscript/Superscript
27,84 Subscript/Superscript Off
27,85,n Unidirectional Printing
27,87,n Double Width On
27,89,n1,n1,d1,d2,d3,... 120 DPI Image Graphics Mode, Normal Mode
27,90,n1,n2,d1,d2,d3,... 240 DPI Image Graphics Mode
27,93 Reverse Line Feed 1/6"
27,94,n Print Characters Below 32
27,61,C1,C2,C3,C4,C5,C6 Load User's Font
27,33 Return to Tandy Mode
------------------------------------------------------------------------
NOTES: The following control codes are available when character set 1 is
selected.
135 BEL (Same as 07)
136 BS (Same as 08)
137 HT (Same as 09)
138 LF (Same as 10)
139 VT (Same as 11)
140 FF (Same as 12)
141 CR (Same as 13)
142 SO (Same as 14)
143 SI (Same as 15)
146 DC2 (Same as 18)
148 DC4 (Same as 20)
152 CAN (Same as 24)
155 ESC (Same as 27)
The control code preceded by an ESCape code is handled in the same way as a
control code not preceded by and ESCape code.
(smm 07/26/93)
Privacy Policy