EGM-1  (250-4035)                  Setup               Faxback Doc. # 4479

Power up all equipment.  Use you system owner's manual for instructions on
powering your computer and other peripherals.  The selection of Mode 1 or
Mode 2 is performed automatically according to the software used.

After powering up the system, you may need to adjust the display of the
EGM-1.

DISPLAY ADJUSTMENT

The 3 display adjustment controls are concealed in the control box.  Gently
pull open the panel door to the right of the video screen.

TEXT FUNCTION--Pressing this button translates white characters to green
characters.  Press once to engage this function.  Press again to disengage.

CONTRAST AND BRIGHTNESS--Use these controls to adjust the screen brightness
to compensate for room lighting.  Rotate either or both controls clockwise
to increase brightness.  Rotate counterclockwise to decrease brightness.

The contrast control is also used to adjust color brilliance--low or high
as needed.  Gently pull out the knob and turn it.  With the control pushed
in, the contrast returns to a preset value.

VERTICAL SIZE--The 2 vertical size controls are located on the rear panel.
If necessary, rotate either control to adjust the adjust the vertical size
of the display.

Use the one that corresponds to the current Mode 1 or 2.

NOTES:

1. Use the BRIGHTNESS and CONTRAST controls with care.  When the same
   characters or graphics are shown for a long time with these controls set
   to maximum positions, part of the screen may be damaged.

2. Adjust only those controls that are described in this manual.  Improper
   operation of other controls may result in possible damage and will
   require the services of a technician to restore proper operation.

(abo-07/27/93)

Privacy Policy