DMP 106 (260-2802) Ribbon Faxback Doc. # 4406
RIBBON INSTALLATION/REPLACEMENT
Black Fabric Cartridge Ribbon (260-1288)
If the Ribbon Cassette is already installed, simply check to see that it
properly threaded between the paper and the Print Head.
If the Ribbon Cassette is not installed, or if it must be replaced due to
excessive wear, faint printing, etc., follow this procedure:
1. Set the Power Switch to OFF.
NOTE: When you turn the power OFF, any information stored in the Printer's
buffer will automatically be lost.
2. Open the Top Cover.
3. Gently grasp the Ribbon Cassette and remove the Cassette by lifting it
upward.
NOTE: Every time you replace the ribbon cassette, clean the two ribbon
guide posts (located at the left end of the carriage shaft) with a
soft dry cloth.
4. Unwrap the new Cassette and remove the packing foam.
5. Gently move the Print Head to the extreme right.
CAUTION: Be sure the Printer power is OFF before manually moving the Print
Head.
6. Hold the new Ribbon Cassette and pass the ribbon end around the Ribbon
Guide Posts near the left edge of the Printer; then move the Cassette
toward the right to draw out the ribbon.
7. Gently press the Cassette down until it is firmly secured by the Stopper
Claw of the Cassette Holder.
Do not force the Cassette into place! If the Cassette is not properly
fitted, the Cassette Knob will not match up with the shaft form the
Cassette Holder. Do not force the Cassette down, but fit it in gradually
while pushing and turning the Cassette Knob in the indicated direction.
8. Once the new Cassette is installed, move the carriage back and forth
manually. The ribbon will be gradually inserted between the Ribbon
Guide and the Print Head.
9. Keep moving the Carriage and check that the ribbon advances properly.
If the ribbon has not been properly fitted between the Ribbon Guide and
Print Head (i.e., into the Print Head Guide Bezel), the ribbon will not
operate smoothly.
10. Close the Top Cover
(abo-07/26/93)
Privacy Policy