DWP 410  (260-1250)            Self-Test               Faxback Doc. # 4378

Before using the DWP-410, you should perform the Self-Test to ensure that
the Printer is operating properly.  Before running the Self-Test, however,
you should load wide paper (15") into the Printer.


To run the Self-Test:

1. Set the Printer Power ON/OFF Switch to ON.

2. Set the ON-LINE/OFF-LINE Switch to OFF-LINE.

3. Set the TEST Switch to ON.

4. If necessary adjust the Paper Thickness Adjustment Lever and the Print
   Impression Switch for best quality. Open the cover: the Self-Test will
   stop.  Adjust the Lever and/or Switch.   Close the cover and the
   Self-Test will resume.

To end the Self-Test, set the Test Switch to OFF.

(css 07/27/93)

Privacy Policy