DMP 2110
(260-2810) Settings Faxback Doc. # 4342
The function switches can be found next to the parallel printer cable
connector on the rear of the printer.
SW SYMBOL OFF ON
Bank # 2 (S2)
1 Form Length 11" 12"
2 LF Pitch 1/6 1/8
3 1" Skip Not Valid
4 Buzzer Valid Not Valid
5 Character Set ASCII Tandy
6-9 International set
10 Not Used --- ---
Function SW9 SW8 SW7 SW6
USA Off Off Off Off
Germany Off Off Off On
France Off Off On Off
Norway Off Off On On
Sweden Off On Off Off
Denmark Off On Off On
Finland Off On On Off
Italy Off On On On
Spain On Off Off Off
England On Off Off On
Belgium On Off On Off
Holland On Off On On
USA On On Off Off
USA On On Off On
USA On On On Off
USA On On On On
Bank # 3 (S3)
1 Mode TANDY IBM
2 Processing DP WP
3 Character Set TRS IBM-1
4-6 Character Style
7 NL/CR CR+LF CR
8 LF/NL LF CR+LF
Function SW6 SW5 SW4
Standard-10 Off Off Off
Standard-12 Off Off On
Condensed-16.7 Off On Off
Correspond-10 Off On On
Correspond-10 On Off Off
Correspond-12 On Off On
Proportional On On Off
Proportional On On On
Bank # 4 (S4)
Print Correction Switches
The print correction switches (S4) on the control PCB are set to the proper
position before the printer is delivered. If the print position shifts
horizontally after the user changes the carriage motor or print head, set
the switches again.
NOTE: Refer to the service manual, page 6, for proper adjustment of
the print correction switches. The replacement of the carriage motor
or print head should not be performed unless you have a service manual
available.
(css 07/26/93)
Privacy Policy