DMP 2110 (260-2810) Ribbon Installation Faxback Doc. # 4340
Black Ribbon (260-1442)
RIBBON INSTALLATION/REPLACEMENT
If the ribbon cassette is already installed, simply check to see that it is
properly threaded between the head mask and the print head.
If the ribbon cassette is not installed, or if it must be replaced due to
excessive wear, faint printing, etc., follow this procedure:
1. Set the power switch to OFF. (NOTE: When you turn the power OFF, any
information stored in the Printer's buffer will automatically be lost.)
2. Open the top cover.
3. Gently grasp the ribbon cassette at the corners nearest the paper and
remove it by lifting both sides.
4. Unwrap the new cassette and remove the packing foam. Before inserting
the new cassette, tighten the ribbon by turning the knob in the
direction indicated by the arrow.
5. Insert the exposed ribbon between the head mask and the print head.
Then, place the ribbon cassette on the cassette holder, and press down.
The ribbon cassette is set. Do not force the cassette into place! If
the cassette is not properly fit, the cassette knob will not match up
with the shaft from the carriage. Do not force the cassette down, but
fit it in gradually while turning the cassette knob in the indicated
direction.
6. Once the new cassette is installed, be sure the ribbon is in between the
head mask and the print head. If necessary, tighten the ribbon by
turning the cassette knob in the indicated direction.
7. Move the carriage back and forth manually to check that the ribbon
advances properly. If the ribbon has not been properly fitted between
the head mask and the print head, the ribbon feed will not operate
smoothly.
8. Close the top cover. If it is hard to insert the ribbon between the
print head and the head mask, move the copy control lever to position
#4, and insert the ribbon. After setting the ribbon cassette, move the
copy control lever to the correct position.
(css 07/26/93)
Privacy Policy