IBM MM50 Monitor
(250-0464)            Power Management                Faxback Doc. # 37001

To benefit from this feature, the monitor must be used with a computer,
video adapter and operating system that are hardware and software enabled
for VESA Display Power Management Signaling (DPMS).

The power management feature is invoked when the computer recognizes
that you have not used your mouse or keyboard for a user definable period
of time.  There are several states, progressively lowering monitor power
consumption as follows:

1.  On

The monitor is fully operational for normal use.  The power indicator
light shows steady green.

2.  Standby

After a defined period of inactivity, the monitor will be instructed by
the computer to enter the Standby state.  The monitor screen will go
blank, and the power indicator light will flash and amber.  Pressing
a key, or moving the mouse will restore normal operation and the screen
image will reappear without any delay.

3.  Suspend

After a further period of inactivity, the computer will instruct the
monitor to enter the Suspend state.  The screen will remain blank and the
power indicator light will continue to flash green and amber.  Energy
savings in this state meet the EPA Energy Star power consumption
requirements (30 watts maximum).  To reactive the monitor, simply press a
key or move the mouse.  The screen image will reappear after a slight
delay.

4.  Off

After a further period of inactivity, the computer with instruct the
monitor to enter the Off state.  The screen will remain blank and the
power indicator light will show steady amber Energy savings in this
state meet the power consumption requirements of Swedish NUTEK
specification 803299/94 (below 8 watts).  To reactivate the monitor,
simply press a key or move the mouse.  There will be a few seconds delay
before the screen image reappears.

As an Energy Star Partner, IBM has determined that this product meets
Energy Star guidelines for energy efficiency.

(/BKL-06/24/97)

Privacy Policy