Citizen PROjet II  (260-2957)  Manual Paper Insertion  Faxback Doc. # 14698

CAUTION:  If you intend to insert single documents continuously, you must
          first switch off the printer, set selector E in its ON position
          (see the section entitled "Parameter Selector Procedure", and
          then switch the printer on again.  It is not necessary to change
          selector E for individual pages or envelopes.

          The sheet of paper/envelope must not be crumpled or torn,
          otherwise it may jam or even not be inserted.

1.  With the printer switched on, position the sheet of paper in the paper
    insertion slot, aligning it with the paper guide which is engraved at
    the left edge of the insertion slot.  (Envelopes (short side) should
    be aligned with the guide engraved at the right edge of the insertion
    slot.)

2.  Push the paper in until it stops against the feed rollers.

3.  Press FORM FEED; the sheet will fed in and aligned at the first print
    position.

4.  Send the text to be printed.  After printing, the paper is expelled
    through the rear of the printer    into the paper output tray.


(LB/all-04/21/95)

Privacy Policy